* rework iso14443b device functions
* hf_read_rx_xcorr.v: transfer i/q pair in one 16bit frame
* hi_read_tx.v: invert ssp_dout. When nothing is transferred (ssp_dout=0), this results in no modulation (carrier on)
* adjust arm sources accordingly
* iso14443b.c: switch off carrier after hf 14b sri512read and hf 14b srix4kread
* iso14443b.c: fix DMA circular buffer handling
* FPGA Hi-Simulate: Formatted code
* FPGA Hi-Simulate: Fixed documantation
* FPGA Hi-Simulate: Freed up 4 LUTs
* FPGA Hi-Simulate: Added 212kHz SSP-Clock option
* Legic: Moved card simulator into separate file & cleaned interface.
Reader and card simulation have almost no common code. Moreover the sim
uses an SSP Clock at 212kHz for all timings to prevent any drifting from
the PRNG. This clock speed is not available in reader simulation mode (SSP
runs at up to 3.4MHz, and changes speed between TX and RX). For these
reasons having the code in separate files makes it significantly cleaner.
* Legic: Implemented RX and TX for card simulation
* Legic: Implemented setup phase for card simulation
* Legic: Implemented read command for card simulation
* Legic: Implemented write command for card simulation
* ISO15693 device side improvements
* increase accuracy by doubling the sample frequency (hi_read_rx_xcorr.v)
* adjust armsrc/iso15693.c and client/cmdhf15.c accordingly
* use more accurate approximation for sqrt(ci^2 + cq^2)
* improve EOF detection (was often mistaken for Logic0, resulting in "error, uneven octet! (extra bits!)")
* hi_read_r_xcorr.v: avoid overflows during accumulation and truncation
* explicitely cast unsigned ADC samples to signed
* more timing fixes
* correctly determine correction bit (taken from iceman's fork)
* add checking of Access Conditions for Read command
* never allow reading KeyA
- fix: IQ demodulator (FPGA)
- fix: approximately align reader signal delay to tag response delay (FPGA)
- fix: remove deprecated RSSI calculation to improve decoder speed (iso14443b.c)
- fix: better approximation of signal amplitude to avoid false carrier detection (iso14443b.c)
- fix: remove initial power off in iso14443b raw command (iso14443b.c)
- add: enable tracing for iso14443b raw command (iso14443b.c)
- fix: client crashed when checking CRC for incomplete responses (iso14433b.c)
- speeding up snoop to avoid circular buffer overflow
- added some comments for better documentation
- rename functions (iso14443 -> iso14443b)
- remove unused code in hi_read_rx_xcorr.v
- most significant bit of tag data (which happens to be the sign bit)
had been dropped when snooping (FPGA change)
- avoid trying to decode both tag and reader data when snooping (we don't
have the time to do so).
